MicroMacro open file dialog bug
Posted: Wed Feb 12, 2014 12:43 am
After writing a long description of the strange behavior I was having, I finally figured out what was causing it. There is a bug with the new open file dialog.
To reproduce problem:
Press enter to open the dialog. MM is now screwed whether you use the dialog or not.
Observed behavior:
If you start any script such as RoMBot, keypresses such as End, Delete and Ctrl-L become unresponsive. It seems to be able to accept 1 keypress if you hold it down for a few seconds, eg. if you hold End down for a few seconds it pauses but then wont accept anymore keypressess. If instead you hold Ctrl-L down for a few seconds the script terminates.
If you manage to terminate the script then you get other strange behavior.
If you then try to start any script withit immediately ends with a "Script forcibly terminated".
If you run a script withso you get the message
it wont accept any keypresses. If you then switch to another window and then switch back, the moment it's active again it stops with the message "Stopping execution".
Hopefully there are enough clues for you to figure it out.
To reproduce problem:
Press enter to open the dialog. MM is now screwed whether you use the dialog or not.
Observed behavior:
If you start any script such as RoMBot, keypresses such as End, Delete and Ctrl-L become unresponsive. It seems to be able to accept 1 keypress if you hold it down for a few seconds, eg. if you hold End down for a few seconds it pauses but then wont accept anymore keypressess. If instead you hold Ctrl-L down for a few seconds the script terminates.
If you manage to terminate the script then you get other strange behavior.
If you then try to start any script with
Code: Select all
startMacro(main,true)
If you run a script with
Code: Select all
startMacro(main)
Code: Select all
The macro is currently not running. Press the start key (F5) to begin.
You may use (F6) key to stop/pause the script.
Hopefully there are enough clues for you to figure it out.